The start address of the Merger affects how the DMX-B data is used. If the address is set to 1, there is no offset of DMX-B. (i.e. Slot 1 of DMX-A and Slot 1 of DMX-B are HTP-merged and result is output to Slot 1 on the DMX OUT).

      

If you set the Merger’s address to 101, in Modes 1 and 2, DMX level of slot 1 of DMX-B is merged with slot 101 of DMX-A and the result output as slot 101 on the DMX OUT. That implies that a number or trailing slots of the DMX-B input are lost (truncated).

      

      

With the Merger’s address set to 101, in Modes 3 and 4, DMX slot 1 from DMX-A goes out to slot 1, regardless of DMX-B’s level (i.e. the first 100 address slots of DMX-B are ignored). At DMX slot 101, slot 101 from both A and B are merged HTP and output to slot 101 on the DMX OUT.

      

      

     

Append Modes

In Modes 9 and 10, the merge engine is not used and a non-001 start address, or offset, is necessary.  The offset determines how much of DMX-A will be used before signal from DMX-B will inserted, or appended, to the DMX OUT..

      

This mode would typically be used in an installation where one dimmer rack is shared between two rooms. In the example below, each room has a twelve channel console running half of the dimmer pack.

     

      

Automatic Backup

 

Modes 5 and 6 automatically switch to the DMX-B stream when data is not present on DMX-A. In Mode 5, when no DMX is present, the #1007 will hold the last look for 2 seconds before switching to DMX-B. In Mode 6 the #1007 will hold it for 5 minutes before switching

One application for this mode is when you have a backup console in case the main console goes down. In this drawing, the Main Console is feeding Go commands to the Backup Console with Midi Show Control (MSC), placing them in sync with both outputting the same levels. The Merger’s output will always be from DMX-A, unless DMX-A dies. Then the #1007 will automatically take the signal from the Backup Console.

     

      

Another usage of this mode has the house light controller is plugged into the DMX-B side.  As long as the show console is turned off, the house light controller has control of the house lights. But, if the show console is on (DMX present on the DMX-A side), the show console will have complete control of the whole output range. 

Backup using a Switch

 

In the above example, the mere presence of DMX on the DMX-A port means that it wins. If more control is desired, use Mode 7 (2 second hold) or Mode 8 (5 minute hold). These modes use a the Contact Input terminals. When the terminal pins are closed (shorted together), using a dry contact closure, DMX-B wins. When the pins are open, DMX-A wins.



         

The switch between the two sources is immediate. If you require a crossfade between DMX-A and DMX-B, look into Pathports; they offer that functionality.